Glass weave visible???

Welcome to the new Bear Mountain Builders Forum - an interactive internet service we provide to encourage communication between canoe and kayak builders
Post Reply
Posts: 41
Joined: Fri May 21, 2004 9:28 am
Location: South Africa

Glass weave visible???

Post by geordie » Fri Aug 25, 2006 5:36 am

I have basically smoothed the canoe down after the last filler coat of epoxy and there are a few patches where I have gone through the glass. I dread the idea of yet another epoxy coat. Is it possible to apply fresh epoxy to these areas with a sponge roller so as not to cause too many runs, or too thick a build up? Any other suggestions would be appreciated.


tom in caledonia
Posts: 45
Joined: Tue Jul 20, 2004 1:13 pm
Location: Caledonia ON

Post by tom in caledonia » Fri Aug 25, 2006 6:01 am

Sure Geordie. I've used a brush and put a thin layer just over the affected area and then very carefully sanded the area after the epoxy cured, feathering it in. A roller would be OK too.

Post Reply