Settingup molds on a long strongback.

Welcome to the new Bear Mountain Builders Forum - an interactive internet service we provide to encourage communication between canoe and kayak builders
Post Reply
cagreen
Posts: 9
Joined: Sun Nov 12, 2006 8:58 pm
Location: Rondeau, Ontario

Settingup molds on a long strongback.

Post by cagreen » Thu Dec 07, 2006 1:40 pm

Strong back is built! Now I'm looking at cutting and setting up the molds. My Cottage Cruiser is 15 1/2" and the strongback is 16" long. I read in Canoecraft that when building a shorter canoe on a longer strongback that you should raise the molds about 2" to leave room for the stems. Any suggestions on the best way to do this? Should I make the station molds 2" higher, or set the mold on blocks to raise it up?
Finally, I'm having trouble visualizing why I would need to raise it up. Can anyone explain this too me a bit more?


Thanks
-Craig

User avatar
Glen Smith
Posts: 3719
Joined: Sat May 08, 2004 9:08 am
Location: Baie-St-Paul, Quebec, Canada

Post by Glen Smith » Thu Dec 07, 2006 2:07 pm

The best way is to make all the molds a few inches higher. The reason is so you can shape the ends of the stems without interference and without always bashing your knuckles on the strongback.

Post Reply