I am about half way through stripping my wee lassie II with aspen strips. This wood has proven to be very stiff and does not like to twist except with very careful and patient placement of my u blocks and wedges to hold them down. I am able to do one strip at a time only but I am ok with it since I am still working full time and should be ready to hit it hard when I am jobless again in a bout a month.
Anyway, In the very cheeked areas at stem and stern The strips are pulled up at stations, I think, 3,4 and five. To pull it back down I am considering epoxying in some blocks at each station on the inside of the hull and pulling it back to the mold with string or rope to continue stripping and to allow me to fair,sand, and fiberglass the outside. I have tried hot glue but the aspen is just too strong for the glue to hold. I thought about fish line and I wonder what test I would need to use? The other problem with fish line is I am stripping with the cove up.
Does anyone have any pictures of something similar or other recommendations?
Thanks
Todd
Pulling hull back down to molds halfway through stripping
- TC in Twin Lake 1
- Posts: 35
- Joined: Thu May 05, 2011 8:06 pm
- Glen Smith
- Posts: 3719
- Joined: Sat May 08, 2004 9:08 am
- Location: Baie-St-Paul, Quebec, Canada
Re: Pulling hull back down to molds halfway through strippin
Go to this link: http://www.greenval.com/builders.html and scroll down to th 5th picture. Martin shows a technique which I have tried with success but with one small difference, I drilled a clearance hole for the screw before gluing the blocks to the hull.
- TC in Twin Lake 1
- Posts: 35
- Joined: Thu May 05, 2011 8:06 pm
Re: Pulling hull back down to molds halfway through strippin
Thanks, Glen. That is exactly whaat I was looking for. It is a "challenge" to get the aspen to do what I woant it to do using the stapleless method. DO you htink wood glue is strong enough?
- Glen Smith
- Posts: 3719
- Joined: Sat May 08, 2004 9:08 am
- Location: Baie-St-Paul, Quebec, Canada
Re: Pulling hull back down to molds halfway through strippin
Yes, ordinary wood glue is fine. Let it set before screwing to stations.