lofting tables
lofting tables
I started lofting my " Ranger " . Had a few discrepancies.There was a few points that were a little off so I stayed with the WLs mostly. And then I started the stem and stern table and it has some miss prints. Is there a correction page I can go to. Hope so,
- Glen Smith
- Posts: 3719
- Joined: Sat May 08, 2004 9:08 am
- Location: Baie-St-Paul, Quebec, Canada
Re: lofting tables
See the corrections here: http://bearmountainboats.com/2012BACKUP ... estems.htm
Re: lofting tables
I have come across a discrepancy on station 5 on the ranger lofting tables where it says on the 24 inch half breadths , which is the bottom of station 5 it measures 5/16 and that would make the bottom flat. Is that a correct measurement? I am really enjoying this process. Hope you can help me.
Re: lofting tables
Is there an updated link fot the above post?