To router or not to router

Welcome to the new Bear Mountain Builders Forum - an interactive internet service we provide to encourage communication between canoe and kayak builders
Post Reply
JesseP
Posts: 46
Joined: Fri Apr 10, 2015 11:13 am
Location: East Central, AB

To router or not to router

Post by JesseP » Wed Feb 24, 2016 10:29 pm

Just pondering over the idea of using a round over bit on on inwales and outwales before I finish the canoe. I have already broken the edge with a spoke shave and sand paper... Just I little hesitant to take a power tool to it ie..tear out is a big fear.

Any ideas of how to get the best edge on the gunwales would be awesome!

Thanks again.
I'm up to my torch.

User avatar
Cruiser
Posts: 625
Joined: Sat Apr 27, 2013 10:21 am
Location: Bowmanville, Ontario

Re: To router or not to router

Post by Cruiser » Wed Feb 24, 2016 11:01 pm

I used a round over bit and it worked fine, just pay attention to the grain direction. If you are worried, you can sand the edges, but routing is a better shape IMO.


Brian

User avatar
Jim Dodd
Posts: 1178
Joined: Wed Feb 08, 2006 11:08 pm
Location: Iowa

Re: To router or not to router

Post by Jim Dodd » Thu Feb 25, 2016 9:19 am

Before installing mine, I route the bottom inside edge of my gunnels, it's hard to do once installed.
After they are installed, I route both top edges.
If you are concerned about tearing up your gunnels, set your bit shallow, so it just takes a little with the first pass, then readjust a little until you are happy.

Good Luck !

Jim
Keep your paddle wet and your seat dry!

Post Reply