NewSpring Clamps for Bead and Cove Stripping

If you know a good tip or technique to help get through a construction "stumbling block", please post it here. If you have questions concerning building problems, please post them on the "Builders' Forum".
User avatar
cedarphile
Posts: 15
Joined: Sun Jan 22, 2017 11:41 am

Re: NewSpring Clamps for Bead and Cove Stripping

Post by cedarphile » Fri Dec 21, 2018 3:30 am

Jim,
Here's another system of using spring clamps to hold strips together to ensure hairline joints.

Harbor Freight sells an immensely strong little spring clamp for under two bucks with serrated rubber ends that really grips the strip below tightly without marring. Couple that with pieces of 1/4" dowel to protect the cove edges and you have a two-part clamping system for less than $2 per unit. You can really push down hard on these clamps to get strips tightly into alignment with the strip below and these little clamps will hold the strip perfectly.
Attachments
clamps in use.jpg
push on clamp.jpg
clamping system close up.jpg

User avatar
Jim Dodd
Posts: 1163
Joined: Wed Feb 08, 2006 11:08 pm
Location: Iowa

Re: NewSpring Clamps for Bead and Cove Stripping

Post by Jim Dodd » Fri Dec 21, 2018 11:13 pm

I may check into those clamps !

The good thing about my clamps, you only need one hand, the inner tube keeps constant pressure, on the strip, if the clamp should slip slightly, and the plastic tubing is always with the clamp, no bending over to pick it up if I drop it !
There is a Harbor Freight store about 75 miles away. Time for a road trip.

Jim
Keep your paddle wet and your seat dry!

Post Reply