Marking Station Mold Positioning At Sheer Line

If you know a good tip or technique to help get through a construction "stumbling block", please post it here. If you have questions concerning building problems, please post them on the "Builders' Forum".
Post Reply
Bernie in Illinois

Marking Station Mold Positioning At Sheer Line

Post by Bernie in Illinois »

It may be an obvious tip for many, but I found it helpful to mark off the position of each mold along the sheer line before pulling the hull away from the mold. That way, I had an accurate way of identifying hull center, and a means of positioning thwarts and/or yoke without fear of skewing.
Peter Kotowych
Posts: 145
Joined: Sun May 09, 2004 8:10 pm
Location: Midland, Ontario

Post by Peter Kotowych »

Bernie,

Now you tell me!

Unmarked Pete
Post Reply