Narrow Strips

Dingo Lab · Post by **Dingo Lab** » Sat Jul 10, 2004 6:50 pm

I am about to begin stripping. The ceder strips I have will end up being about a sixteenth of an inch narrower than the recommended 3/4 inch. Other than needing more strips to complete the hull, is this going to cause any problems for me?

Thanks.

Guest · Post by **Guest** » Sat Jul 10, 2004 7:10 pm

No problem. In fact some people mill very narrow strips to use in difficult areas such as the bilge and closing in the center.
Dave

Glen Smith · Post by **Glen Smith** » Sat Jul 10, 2004 7:11 pm

No problem at all, in fact I sometimes use even narrower strips (5/8" or 1/2") for the turn of the bilge or for curved strips on kayak decks.

Enjoy your project.