Greetings Friends,
As i look at the blueprints for the freedom solo, the main elevation shows the 15' version, with exact locations notated for the seat, thwarts and center of buoyancy.
I have built the stretch version; am I to assume that everything stays the same relative to the station mold locations?
Thank You
freedom solo blueprint question
-
- Posts: 39
- Joined: Fri Apr 29, 2011 2:37 pm
- Location: st louis Mo
-
- Posts: 30
- Joined: Wed May 12, 2004 3:16 pm
- Location: Midland, Ontario, Canada
Re: freedom solo blueprint question
Anthony,
The seat location should be scaled just like the rest of the boat. That means all length-wise dimensions shown on the drawing would be increased by a factor of (12.75) / 12 = 1.0625.
You can do the same with the thwart locations, although I thought about this for a bit - whether they would stay the same absolute distance apart. On further reflection, I think they are best to be expanded as well to support the gunnel.
I look forward to seeing some in-the-water photos.
Regards,
Steve
The seat location should be scaled just like the rest of the boat. That means all length-wise dimensions shown on the drawing would be increased by a factor of (12.75) / 12 = 1.0625.
You can do the same with the thwart locations, although I thought about this for a bit - whether they would stay the same absolute distance apart. On further reflection, I think they are best to be expanded as well to support the gunnel.
I look forward to seeing some in-the-water photos.
Regards,
Steve
-
- Posts: 39
- Joined: Fri Apr 29, 2011 2:37 pm
- Location: st louis Mo
Re: freedom solo blueprint question
Thanks Steve! I promise to post some pictures when she is in the water...