New builder here. Thanks in advance.
After soaking, forming, and drying three days, laminated, with thickened epoxy, the inside and outside stems to the molds. Waited over night, then removed epoxied stems. Inner and outer matched well. Mounted all station and stem molds to strongback. When re-laying stems over stem molds, they seem to have sprung out somewhat and will need to be clamp to reform to mold (although they, when put together, still form to one another). Should they be closer to the original mold when fitted, or is this a normal process to spring out and need some help fitting to mold? Judging by some photos in Canoecraft, and elsewhere, it seems as though I may have done something wrong in the lamination process. Just worried that if I clamp inner to mold, lay up strips, I will have a problem down the road with the outer connection. Before I continue on the build, I'd like to know the process is right.
Mark
Stems To Stem Molds
Re: Stems To Stem Molds
It seems to me, once the clamps, that hold the stems to the stem form, are removed. There is undo pressure on the glue joint between the inner stem, and the strips.
This could be avoided, when steam bending, by using a form that over bends the stems.
Jim
This could be avoided, when steam bending, by using a form that over bends the stems.
Jim
Keep your paddle wet and your seat dry!
Re: Stems To Stem Molds
Thanks, Denis. I guess maybe I was overthinking it a might, but I figured it was better to as a silly question rather than make a stupid mistake.
I agree Jim, but what you suggest would mean making two different sets of molds and trying to over adjust leaving me with the opposite problem as now, no?
I agree Jim, but what you suggest would mean making two different sets of molds and trying to over adjust leaving me with the opposite problem as now, no?
- Patricks Dad
- Posts: 1476
- Joined: Wed Oct 13, 2004 1:11 pm
- Location: Warrenville, Illinois
Re: Stems To Stem Molds
A little spring-back on your stems once laminated is fine. The outer stems may require a bit of clamping when you apply them too but if they fit together well when you glued them up, they will fit fine later. The pressure on them (and the strips) once the hull is stripped is minimal.
Re: Stems To Stem Molds
Good to know PD. Thanks for the input.
Am now relaxed and ready to carry on.
Am now relaxed and ready to carry on.