Did the skill saw method and it worked great once I built some jigs to assist with stabilizing the planks and got a friend to move clams while I mushed to saw. I now have a new issue. In an effort to decrease the weight of the canoe, I am planing down the strips to 0.222 thickness. I have borrowed an older Ryobi 10 thickness planer from a friend. I an having a very difficult time getting the planks to come out with a consistent thickness. a single 16' plank will often come out of the planer with a thickness of 0.222 to 0.227. It is an older machine, but I am not certain if the machine is the issue or the softness and thinness of the planks. My concern is that when I get to routing the bead and cove this variation may be a problem.
Thoughts or suggestions???
Nokomis
-
- Posts: 24
- Joined: Tue Jun 02, 2020 7:08 pm
Re: Nokomis
Diego,
When I keep my gratitude a little higher than my expectations, it's usually a good day.
When I keep my gratitude a little higher than my expectations, it's usually a good day.
-
- Posts: 24
- Joined: Tue Jun 02, 2020 7:08 pm
Re: Nokomis
Did the skill saw method and it worked great once I built some jigs to assist with stabilizing the planks and got a friend to move clams while I mushed to saw. I now have a new issue. In an effort to decrease the weight of the canoe, I am planing down the strips to 0.222 thickness. I have borrowed an older Ryobi 10 thickness planer from a friend. I an having a very difficult time getting the planks to come out with a consistent thickness. a single 16' plank will often come out of the planer with a thickness of 0.222 to 0.227. It is an older machine, but I am not certain if the machine is the issue or the softness and thinness of the planks. My concern is that when I get to routing the bead and cove this variation may be a problem.
Thoughts or suggestions???
Thoughts or suggestions???
Diego,
When I keep my gratitude a little higher than my expectations, it's usually a good day.
When I keep my gratitude a little higher than my expectations, it's usually a good day.
- Patricks Dad
- Posts: 1476
- Joined: Wed Oct 13, 2004 1:11 pm
- Location: Warrenville, Illinois
Re: Nokomis
I'd get the router set up going to see if you really have a problem there. I'd guess 5 thousandths of an inch won't be an issue (actually that's .224 +/- only 2 or 3 thousandths...
Re: Nokomis
I've cut strips as thin as 1/8" with the Skilsaw. For the Inserts on my Composites. They came out very uniform, and no planing required.
I didn't bother bead and coving, as there is no need, for that thin of a strip..
The Skilsaw did a very uniform cut. I would use a Caliper to check the spacings for the fence to blade.
I didn't bother bead and coving, as there is no need, for that thin of a strip..
The Skilsaw did a very uniform cut. I would use a Caliper to check the spacings for the fence to blade.
Keep your paddle wet and your seat dry!
-
- Posts: 24
- Joined: Tue Jun 02, 2020 7:08 pm
Re: Nokomis
thanks for the suggestion Jim, I'll experiment with this.
Diego,
When I keep my gratitude a little higher than my expectations, it's usually a good day.
When I keep my gratitude a little higher than my expectations, it's usually a good day.