Hello all,
First post so I hope I’m doing this right. My first build freedom 17, stripping went fine outer stems gave me fits. Question is sanding hull took fine edge of cove off in numerous spots. Epoxy mix leaves spots that won’t sand out. Seam where outer stem and planks meet could use a lot of filler to make smooth transition. How good does this need to be on my first build and not have problems. Thanks
Fairing and filling gaps
Re: Fairing and filling gaps
Where do you live ?
I'm here in Northwest Iowa.
I'd be glad to personally help mentor you, if not too far away.
I just finished glassing the outside of my 30 something canoe.
Jim
I'm here in Northwest Iowa.
I'd be glad to personally help mentor you, if not too far away.
I just finished glassing the outside of my 30 something canoe.
Jim
Keep your paddle wet and your seat dry!
Re: Fairing and filling gaps
Get Jim to come over if you can swing it, hands on help and guidance is gold
Brian
Brian