Then i made my biggest mistake in that I don't think I waited long enough before attempting the next coat.
I poured some resin onto a flat area and on attempting to spread it out it seemed to all lumpy and pull around what was underneath it.
I decided to stop before i made even more mess and resolved to return today.
My plan now is to give the whole thing a good sanding as it is now quite hard and then follow this with a carefully applied brush coat.I am using west system 105 resin and 207
hardner.
the question/s are..
1.Do i have to sand the hull to a perfect flat surface before this final coat or can I rely on it filling a few uneven areas?
![Thinking :thinking](./images/smilies/econ_thinking%5B1%5D.gif)
regards
Alick
2.would It be best to do my sanding today and leave my coating till next week or do I have to do both today?