Welcome to the new Bear Mountain Builders Forum - an interactive internet service we provide to encourage communication between canoe and kayak builders
Jim Dodd
Posts: 1359 Joined: Wed Feb 08, 2006 11:08 pm
Location: Iowa
Post
by Jim Dodd » Wed Mar 18, 2015 9:23 am
My first Bead and Cove router setup That I've used for at least 20 canoes, and still works fine is going into retirement.
I purchased a used router table, and just finished setting it up. Here are a few pics.
Jim
Keep your paddle wet and your seat dry!
Kermit
Posts: 62 Joined: Mon Nov 28, 2011 9:01 pm
Location: Ottawa, Ontario
Post
by Kermit » Thu Mar 19, 2015 5:57 am
Very nice. Better than my set up, I pushed against the bit and fence. Wish I would have read your 'between the bit and fence' recommendation earlier.
Cheers,
Chris
Jim Dodd
Posts: 1359 Joined: Wed Feb 08, 2006 11:08 pm
Location: Iowa
Post
by Jim Dodd » Thu Mar 19, 2015 8:27 am
Chris
I was LUCKY enough to learn that trick from someone on this site a long time ago !
Jim
Keep your paddle wet and your seat dry!